beautypg.com

Photo storage capacity reference – Bushnell 18-0833 User Manual

Page 12

background image

Image Size

Megapixels

(approx)

Quality *

Internal

Memory**

64 MB CF

Card

XL 2048x1536

3.2

FQ

12 photos

32 photos

NQ

33

92

EQ

54

152

L 1600x1200

2.1

FQ

21

60

NQ

55

156

EQ

89

256

M 1280x960

1.3

FQ

34

96

NQ

87

257

EQ

141

400

S 800x600

0.5

FQ

89

256

NQ

226

644

EQ

362

1036

XS 640x480

0.35

FQ

141

400

NQ

354

1012

EQ

567

1620

Photo Storage Capacity Reference

(

max capacity, +/- 2 photos)

* Selects amount of file compres-
sion (jpg ratio)
(FQ=low/EQ=high)
FQ: Fine Quality (1:4)
NQ: Normal Quality (1:10)
EQ: Economy Quality (1:16)

**Internal RAM available for
photo files: 20MB

Image Size refers to the pixel
dimensions, or resolution, of the
digital file.

Actual storage capacity will vary
based on content of each photo
file. You may be able to take a few
photos more or less than the listed
average capacity.

Use large size and high quality set-
tings for photos you may want to
enlarge or crop later. If required,
they may also be reduced to a
smaller file size using your photo
software. Use small size and/or
low quality settings if you will
only email, insert into documents,
or make small prints, and do not
want to resize the file later.

TWO-YEAR LIMITED WARRANTY
Your Bushnell

®

product is warranted to be free of defects in materials and workmanship for

two years after the date of purchase. In the event of a defect under this warranty, we will,
at our option, repair or replace the product, provided that you return the product postage
prepaid. This warranty does not cover damages caused by misuse, improper handling, in-
stallation, or maintenance provided by someone other than a Bushnell Authorized Service
Department.

Any return made under this warranty must be accompanied by the items listed below:
1) A check/money order in the amount of $10.00 to cover the cost of postage and handling
2) Name and address for product return
3) An explanation of the defect
4) Proof of Date Purchased
5) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit,
with return postage prepaid to the address listed below:

IN U.S.A. Send To:

IN CANADA Send To:

Bushnell Performance Optics

Bushnell Performance Optics

Attn.: Repairs

Attn.: Repairs

8500 Marshall Drive

25A East Pearce Street, Unit 1

Lenexa, Kansas 66214

Richmond Hill, Ontario L4B 2M9

For products purchased outside the United States or Canada please contact your local dealer
for applicable warranty information. In Europe you may also contact Bushnell at:

BUSHNELL Performance Optics Gmbh

European Service Centre

MORSESTRASSE 4

D- 50769 KÖLN

GERMANY

Tél: +49 (0) 221 709 939 3

Fax: +49 (0) 221 709 939 8

This warranty gives you specific legal rights.

You may have other rights which vary from country to country.

©2005 Bushnell Performance Optics

FCC Note:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV
technician for help.

The shielded interface cable must be used with the
equipment in order to comply with the limits for a digital
device pursuant to Subpart B of Part 15 of FCC Rules.

Specifications and designs are subject to change without
any notice or obligation on the part of the manufacturer.

22

23

18-0833 6LIM.indd 22-23

1/28/05 2:47:43 PM