Ice cube tray, Ice pack, Sticker “ok – Neff KI6863F30G User Manual
Page 15: Switching off and disconnecting the appliance, Switching off the appliance, Disconnecting the appliance, Defrosting

en
15
Ice cube tray
Fill the ice cube tray ¾ full of
drinking water and place in the freezer
compartment.
If the ice tray is stuck to the freezer
compartment, loosen with a blunt
implement only (spoon-handle).
To loosen the ice cubes, twist the ice tray
slightly or hold briefly under flowing
water.
Ice pack
(if enclosed, quantity varies)
If a power failure or malfunction occurs,
the ice packs can be used to slow
down the thawing process. The longest
storage time is obtained by placing the
ice pack on the food in the top
compartment.
The ice packs can also be used to cool
food temporarily, e.g. in a cold bag.
Sticker “OK”
(not all models)
The “OK” temperature monitor can be
used to determine temperatures below
+4 °C. Gradually reduce the temperature
if the sticker does not indicate “OK”.
Note
When the appliance is switched on,
it may take 12 hours until
the temperature is reached.
Correct setting
Switching off and
disconnecting the
appliance
Switching off the appliance
Fig.
2
Press the On/Off button 1.
Temperature display goes out,
refrigerating unit switches off.
Disconnecting the appliance
If you do not use the appliance
for a prolonged period:
1. Switch off the appliance.
2. Pull out mains plug or switch off fuse.
3. Clean the appliance.
4. Leave the appliance door open.
Defrosting
Refrigerator compartment
defrosts fully automatically
While the refrigerating unit is running,
beads of condensation or hoarfrost
form at the back of the refrigerator
compartment. This is quite normal.
It is not necessary to wipe off the
condensation or frost. The rear panel
defrosts automatically. The condensation
runs into the condensation channel,
Fig.
,. and is conveyed to the
refrigerating unit where it evaporates.
Note
Keep the condensation channel
and drainage hole clean, so that
the condensation can run out.