Room temperature switch, Ventilation, Installation location – Neff K4336X8 User Manual
Page 22: 3 cm to electric or gas cookers, 30 cm to an oil or coal-fired cooker, Undercounter, Connecting the appliance, Installation location connecting the appliance, En 22

en
22
Note
The appliance is fully functional within
the room temperature limits of the
indicated climatic class. If an appliance
of climatic class SN is operated at colder
room temperatures, the appliance will
not be damaged up to a temperature of
+5 °C.
Room temperature switch
If the room temperature drops below
+16 °C, the freezer compartment of
appliances belonging to climate
class SN may become too warm. In an
extreme case the frozen food may thaw.
To prevent this from happening, switch
on the room temperature switch. As a
result, the refrigeration unit operates
more frequently. The appliance can now
be operated at a room temperature of
+10 °C to +16 °C.
To switch on, press the room
temperature switch, Fig. "/B. Red mark
becomes visible. The light inside the
appliance is lit at a reduced luminosity.
To save energy, switch off the room
temperature switch as soon as the room
temperature exceeds +16 °C.
Ventilation
Fig. !/6
The refrigeration unit is ventilated only via
the ventilation grille in the base. Never
cover the ventilation grille or place
anything in front of it. Otherwise the
refrigeration unit must work harder,
increasing the power consumption.
Installation location
Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e. g. a
cooker, radiator, etc. If installation next
to a heat source is unavoidable, use a
suitable insulating plate or observe the
following minimum distances to a heat
source:
■
3 cm to electric or gas cookers.
■
30 cm to an oil or coal-fired cooker.
Undercounter
An attachment under certain worktops,
e.g. stone, glass or stainless steel, is
frequently not possible. You can order
accessories from customer service for
installation on the side walls.
Connecting the
appliance
After installing the appliance, wait at least
1 hour until the appliance is switched on.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior of the
appliance (see chapter “Cleaning the
appliance”).