BodyCraft BCG-GX - Manual (Page 9)

8
STEP 3 ASSEMBLE CABLE ARM ASSEMBLY
Remember to keep all BOLTS loose to ensure the holes will align easily.
1. Attach Cable Arm Assembly (11) to Cable Arm Connector (17), using two 3/8" X 1" Hex Bolts
(103) and two 3/8" Washers (116) then attach Cable Arm Connector (17) to Front Upright (3),
using two 3/8" X 4" Hex Bolts (97), four 3/8" Washers (116) and two 3/8" Nylon Nuts (124).
2. Attach Cable Arm Assembly (11) and Stabilizing Plate (20A) to Base Frame (1), using two
3/8" X 3-1/4" Hex Bolts (98A), four 3/8" Washers (116) and two 3/8" Nylon Nuts (124). You
may need to loosen the bolts at the top of the Cable Arm Assembly Bottom
Frame to help the holes line up.
3. Slide the axle of each Cable Arm (14) through
the holes on the selector plate in The Cable Arm
Assembly (11) and then fasten using the Steel
Spacer (34), and Axle Collars (35). Tighten the set
screw on the Axle Collars (35) with a 5/16" Allen
Wrench. Check to ensure that each Cable Arm (14)
pivots freely and that cables are not twisted.