Sharp GX-BT3 - Manual (Page 6)

E-5
MUTE ON/ STAND-BY
TREBLE
AUDIO IN
BASS
PAIRING
VOL
X-BASS
BLUETOOTH
DIMMER
RRMCGA343AWSA
ECO MODE
GX-BT3
ON/
STAND-BY
VOL
X-BASS
„ To turn the power on
Press the ON/STAND-BY button to turn the power on.
When the power is first turned on, the speaker frames move
outwards and pneumatic sound will be heard (default setting).
To turn off the pneumatic sound, press and hold the X-BASS
button. The LED lights up and then fades out.
To return to the default setting, press and hold the X-BASS but-
ton again. The LED light will slowly fade in.
After use:
Press the ON/STAND-BY button to enter the power
standby mode.
■ LED light brightness control
Press DIMMER button on the remote control to change
the mode.
Dimmer 1
Dimmer 2
Light Off
Dimmer Off
(LED light dim)
(LED light bright)
(LED light gets dimmer.)
(LED light off during playback only.)
■ Volume auto fade-in
If you turn off and on the main unit with the volume set
to almost maximum, the main unit starts with moderate
volume and fades in to the last set level.
■ Volume control
Press VOLUME +/– buttons (on main unit) or VOL +/– (on
remote control) to increase or decrease the volume.
The LED light will blink when the volume reaches maxi-
mum or minimum level.
„ Function
When the FUNCTION button on the main unit is pressed,
the current function will change. Press the FUNCTION
button repeatedly to select the desired function.
: Pairing indicator lights up.
: LED lights up at the minimum level.
Bluetooth
AUDIO IN
„ Direct key power on function
When you press any of the following buttons, the unit turns on.

/ on the remote control: last selected function activated.
 AUDIO IN on the remote control: audio function activated.
 BLUETOOTH on the remote control: Bluetooth function ac-
tivated
„ Auto power off function
The unit will enter the standby mode if:
Bluetooth:
●
No connection for 60 seconds.
●
In the pause or stop mode for 20 minutes
Audio In: No detection of input signal after 20 minutes
„ X-Bass control
To turn on/off the X-Bass, press the X-BASS button
repeatedly until the desired X-Bass mode appears.
LED will light up according to the desired X-Bass mode.
X-BASS ON X-BASS ON
X-BASS OFF X-BASS OFF
X-BASS ON
X-BASS OFF
X-BASS ON
X-BASS OFF
Note
The X-Bass mode will be set to off when BASS/TREBLE
control is adjusted.
„ Bass and treble control
Press BASS or TREBLE +/- button on the remote control
to increase or decrease the bass or treble level respec-
tively.
LED will light up according to the desired Bass or Treble
level.
+ 4
- 4
- 3
- 2
- 1
+ 3
+ 2
+ 1
0
+ 4
- 4
- 3
- 2
- 1
+ 3
+ 2
+ 1
0
„ Muting
The volume is muted temporarily when pressing the
MUTE
button on the remote control. Press again to
restore the volume.
General control