Sharp HT-SB32D Barre de son - Manual (Page 2)

To mount the sound bar on the wall
1 Fix the pattern paper to the wall in horizontal
position as below.
44 mm
509 mm Wall
surface
Pattern paper
(supplied)
548 mm
2 Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
Wall surface
32 mm
8-9 mm
3 Fix a wall mount plug into the hole using a ham-
mer, until it is flush with the wall surface.
32 mm
8-9 mm
Wall surface
4 Fasten the screws to the wall as shown below.
(Total screw is 2 pieces)
Screw using
Wall surface
Wall surface
Screwdriver
4.5 mm - 5 mm
Gap from wall surface
5 Hang the sound bar onto the screws.
System preparation
1 Peel the double sided tape separator. 2 Fix the spike leg onto the sound bar as shown.
Make sure to unplug the AC power lead before installing the sound bar or changing the position.
Spike leg
Double sided
tape separator
Bottom of
sound bar
HTSB32_QG.indd 2 2014-07-07 08:56:38