Tools – Nokia N80 Internet Edition User Manual
Page 101

Tools
100
Authentication type
—Select
Open
or
Shared
for the
authentication type between your device and the wireless
LAN access point device.
WEP key settings
—Enter
WEP encryption
(length of the
key),
WEP key format
(
ASCII
or
Hexadecimal
), and
WEP
key
(the WEP key data in the selected format).
Security settings for
802.1x
and
WPA/WPA2
:
WPA mode
—Select the means of authentication:
EAP
to
use an extensible authentication protocol (EAP) plug-in, or
Pre-shared key
to use a password. Complete the
appropriate settings:
EAP plug-in settings
(only for
EAP
)—Enter the settings as
your service provider instructs.
Pre-shared key
(only for
Pre-shared key
)—Enter a
password. The same password must be entered on the
wireless LAN access point device.
TKIP encryption
(only for
WPA/WPA2
)—Select whether
Temporal Key Integrity Protocol (TKIP) is used.
Homepage
—Define a home page.
Select
Options
>
Advanced settings
and from the
following:
IPv4 settings
:
Phone IP address
(the IP address of your
device),
Subnet mask
(the subnet IP address),
Default
gateway
(the gateway), and
DNS address
—enter the IP
addresses of the primary and secondary DNS server.
Contact your Internet service provider for these addresses.
IPv6 settings
>
DNS address
—Select
Automatic
,
Well-
known
, or
User defined
.
Ad-hoc channel
(only for
Ad-hoc
)—To enter a channel
number (1-11) manually, select
User defined
.
Proxy serv. address
—Enter the address for the proxy
server.
Proxy port number
—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data conn.
—If you select
When available
and you
are in a network that supports packet data, the device
registers to the packet data network. Starting an active
packet data connection (for example, to send and receive
e-mail) is quicker. If there is no packet data coverage, the
device periodically tries to establish a packet data
connection. If you select
When needed
, the device uses a
packet data connection only if you start an application or
action that needs it.
Access point
—The access point name is needed to use your
device as a packet data modem to your computer.