Bulldog Security RS602E - Manual (Page 14)

13
Keyless Entry Operation
Press button #2 (lock/unlock), the parking lights will flash once and the doors will lock. Press
button #2 again, the parking lights will flash twice, the doors will unlock, and the parking lights
will remain on for one minute or until you turn the ignition on or press the brake.
Dome Light Supervision Option
The remote starter includes an optional output that can be used to illuminate the dome light when
pressing button #2 and unlocking your power door locks. The dome light will remain on for one minute
or until you turn the ignition on or press the brake.
Trunk Pop Output
The remote car starter includes an optional output that can be used to do one of the following: open
the trunk (optional relay required), roll up the windows (optional module needed), close the sun
roof (optional module needed) etc. This output will pulse .75 seconds when pressed and released. In
instances where a continuous signal is needed such as sun roof and power windows, hold down Button
#3 (trunk) as long as the signal is needed to complete the task. The parking lights will remain on
as long as this button is being pressed.
Remote Car Finder (Armed Only)
When the unit is armed, press and release Button #4, the horn or siren will chirp three (3) times
and the parking lights will flash three (3) times.
Runtime Confirmation (Disarmed Only)
With the engine off, press and release Button #4 (stop). The parking lights will begin to flash,
each flash represents the programmed runtime. Example: 5 flashes = 25 minutes.