Toshiba CV711 - Manual (Page 34)

English
33
CONTROLS AND FEATURES
Press ▲ or ▼ to highlight Base Colour
Adjustment and then press ► or .
7
Advanced Video
Select Back Exit EXIT RETURN
On Cinema Mode
Auto
Off
On
NR
CTI
Adaptive Luma Control
On Active Backlight
Blue Screen
3D Colour Management
Base Colour Adjustment
Enter OK
Press ▲ or ▼ to select an option, then
press to enter the adjustment setting
window.
Red
Hue Saturation Brightness
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
Green
Blue
Yellow
Magenta
Cyan
Base Colour Adjustment
Select Back Exit EXIT Enter OK RETURN
Reset
4
Press ◄ or ► to select Hue, Saturation,
or Brightness, then press ▲ or ▼ to
adjust the settings as required.
NOTE: To return to the original factory settings,
select Reset and press .
HDMI RGB Range
Adjusts RGB full range signal automatically.
When Limit is selected the RGB signal’s output
range is 16 to 235. When Full is selected the
RGB signal’s output range is 0 to 255.
In the PICTURE menu, press ▲ or ▼ to
highlight Advanced Video and press ► or
to enter.
Press ▲ or ▼ to highlight HDMI RGB
Range and press ◄ or ► to select Auto,
Full, or Limit.
NOTE: If the HDMI connection is capable of
1080p and/or the television is capable of refresh
rates greater than 50Hz or supports Deep Colour,
a Category 2 cable will be required. Conventional
HDMI/DVI cables may not work properly with this
mode.
H./V. Position
Adjust the horizontal and vertical position of the
picture.
In the PICTURE menu, press ▲ or ▼ to
highlight Advanced Video and press ► or
to enter.
Press ▼ to highlight H./V. Position and
press ► or to enter.
H./V. Position
Select Adjust OK Back Exit EXIT RETURN
0
0
H.Position
V.Position
Press ▲ or ▼ to select H. Position or V.
Position and press◄ or ► to adjust.
NOTE: For PC input, V. Position adjustment is
not linear. In another words, when you adjust
V. Position, the OSD value will change by 2 or
greater value depending TV's calibration process.
VGA
The VGA adjustment is available only when the
input source is PC and your TV is receiving a
computer signal.
In the PICTURE menu, press ▼ to
highlight VGA and press ► or to enter.
Select Auto Adjust for automatic adjusting,
or press ◄ or ► to manually adjust the
H.Position, V.Position, Phase, or Clock.
Auto Adjust
5
-1
11
127
H.Position
V.Position
Phase
Clock
VGA
Select Back Exit EXIT Enter OK RETURN