Toshiba NB510 User Manual
Page 74
Do not install or remove a memory module while Wake-up on LAN is
enabled.
The Wake-up on LAN function consumes power even when the
system is off. Leave the AC adaptor connected while using this
feature.
Regarding Wake-up on LAN from sleep or hibernation, you must
check the "Allow the device to wake the computer" check box within
the LAN Device properties. (This feature does not effect the Wake-up
on LAN from sleep or hibernation.)
Power will be automatically turned on when a signal is received from an
administrator's computer which is connected via a network.
The following settings can be changed when the Built-in LAN is Enabled.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the
section in chapter 5, Power and Power-Up Modes.
Enabled
Enables Wake-up on LAN from shutdown.
Disabled
Disables Wake-up on LAN from shutdown.
(Default)
Built-in LAN
This feature enables or disables the Built-in LAN.
Enabled
Enables Built-in LAN functions. (Default)
Disabled
Disables Built-in LAN functions.
USB
Legacy USB Support
Use this option to enable or disable USB Legacy Emulation. If your
operating system does not support USB, you can still use a USB mouse
and keyboard by setting the Legacy USB Support item to enabled.
Enabled
Enables the USB Legacy Emulation. (Default)
Disabled
Disabled Disables the USB Legacy Emulation.
SATA
SATA Interface setting
This feature allows you to set SATA interface setting.
NB510
User's Manual
4-11