4preparation – Toshiba BDX1200 User Manual
Page 10
10
E
ng
lis
h
4
Preparation
Always.follow.the.instructions.in.this.chapter.
in.sequence.
Note:
- Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Prepare the remote control
1..Open.the.battery.compartment.
2..Insert.two.R03.batteries.with.correct.
polarity.(+/-).as.indicated.
3..Close.the.battery.compartment.
Notes:
- If you are not going to use the remote control
for a long time, remove the batteries.
- Do not use old and new or different types of
batteries in combination.
- Risk of explosion! Keep batteries away from
heat, sunshine or fire. Never discard batteries in
fire.
• The maximum operable ranges from
the unit are as follows.
-.Line.of.sight:.approx..10.m
-.Either.side.of.the.centre:.approx..7.m.
within.30°
-.Above:.approx..7.m.within.30°
-.Below:.approx..7.m.within.30°
7 m 10 m
7 m
Setting up the player
Find the correct viewing input
1..Press.
1
to.turn.on.this.product.
2..Turn.on.the.TV.and.switch.to.the.correct.
video-in.input.(refer.to.the.TV.user.manual.
on.how.to.select.the.correct.input).
Initial Setting
When you turn on this unit for the first time,
you.need.to.follow.these.steps.
1..A.welcome.page.will.be.displayed.when.
this.product.is.powered.on.
2..Press.OK.to.enter.language.setting.
3..Select.your.desired.language,
resolution.and.aspect.ratio.using./,.then.
press.OK.
4..Press.SETUP.to.exit.the.Setup.menu.
Use the SETUP menu
1.Press. SETUP to. display. the. Setup. menu.
when.the.Blu-ray.Disc
TM
.Player.is.playing.or.
no.disc..And.press.SETUP to.exit.the.Setup.
menu.
Tip:
- When playing high-definition sources
, you must press
STOP.
button to enter
SETUP
.
interface.
Select menu display language
1
.
Press.SETUP, [General Setting] menu
is.displayed.
2..Select.[Language], then.press .
3..Select.[OSD], then.press .
-.The.language.options.may.vary.for.
different.regions.
4..Press /
to.select.a.language,.then.
press OK.
Note:
- If this disc player is connected to a HDMI CEC
compliant TV, skip this setting. It switches
automatically to the same OSD menu language
as per your TV setting.