Toshiba BDX1250 - Manual (Page 20)

20
English
[Audio Output]
• [Spdif]
Select the output mode of COAXIAL
jack, options include Bitstream, PCM,
Re-encode and Off.
{Bitstream} – Output digital signal
without any processing.
{PCM} – Output digital signal with
processing, only two channels export.
{Re-encode} – Auto select signal type
from COAXIAL jack according to the
Audio stream on disc.
{Off} – No output for S/PDIF.
• [HDMI]
Select the output mode of HDMI Out
jack, options include Bitstream, PCM,
Re-encode and Off.
{Bitstream} – Output HDMI digital
signal without any processing.
{PCM} – Output HDMI digital signal
with processing, only two channels
export.
{Re-encode} – Auto select signal type
from HDMI Out jack according to the
Audio stream on disc.
{Off} – No output for HDMI.
• [Down_samp]
Select the digital audio signal sampling
frequency.
{48K} – For discs recorded at sampling
rate of 48 kHz.
{96K} – For discs recorded at sampling
rate of 96 kHz.
{192K} – For discs recorded at sampling
rate of 192 kHz.
• [Dolby DRC]
Select the Dynamic Range Control mode
System Information
1. Press SETUP, [General Setting] menu
is displayed.
2. Press  to select [System
Information].
- The current software version and MAC
address will be displayed.
- Press  to return to the previous
menu.
- Press SETUP to exit the menu.
SETUP Exit
System Information
Move cursor key to select menu option
then use “OK ” key to select
Software version: V XX
MAC: E8-9D-87-XX-XX-XX
which makes it available to listen to a
movie at a low volume without losing
sound clarity.
{Off} – Non-dynamic range compress.
{On} – Dynamic range compress.
{Auto} – Adjust the DRC according to
input audio.
The setting of Auto is effective for Dolby
TrueHD.