Toshiba Tecra S11 - Manual (Page 181)

User’s Manual 8-21
TECRA A11/S11, Satellite Pro S500
External monitor
Please also refer to Chapter 3, Hardware, Utilities and Options , and to the
documentation supplied with your monitor for further information.
Problem Procedure
Monitor does not
turn on After confirming that the monitor’s power switch is
on, you should check the connections to make sure
that the power cord/adaptor is firmly connected to
the monitor and to a working power outlet.
No display Try adjusting the contrast and brightness controls
on the external monitor.
Press the FN + F5 hot key in order to change the
display priority and ensure that it is not set for the
internal display only.
Check to see if the external monitor is connected.
When the external monitor is set as the primary
display device in extended desktop mode, it will not
display when the computer wakes up from Sleep
Mode if the external monitor has been disconnected
while in Sleep Mode.
To keep this from happening, do not disconnect the
external monitor while the computer is in Sleep or
Hibernation Mode.
Remember to turn off the computer before
disconnecting the external monitor.
When the display panel and an external monitor are
set to clone mode and they are turned off by the
timer, the display panel or the external monitor may
not display when turned on again.
If this occurs, press FN + F5 to re-set the display
panel and external monitor to clone mode.
Display error
occurs Check that the cable connecting the external
monitor to the computer is firmly attached.
If you are still unable to resolve the problem, contact
your reseller, dealer or service provider.