Toshiba Tecra A2 - Manual (Page 59)

User’s Manual 3-7
Getting Started
2. While holding down the palm rest with one hand so that the main body
is not raised, lift the panel slowly. Adjust the angle of the panel to
provide optimal clarity.
Opening the display
Turning on the power
This section describes how to turn on the power.
1. If an optional external floppy disk drive is connected, make sure it is
empty. If a floppy disk is in the drive, press the eject button and remove
the floppy disk.
2. Open the display.
3. Press and hold the computer’s power button for two or three seconds.
Turning on the power
Use reasonable care when opening and closing the display panel. Opening
it vigorously or slamming it shut could damage the computer.
Display latch
After you turn on the power for the first time, do not turn it off until you have
set up the operating system. Refer to the section Windows XP setup .
Power button