Toshiba Tecra A2 - Manual (Page 110)

User’s Manual 6-12
Power and Power-Up Modes
Retaining data with power off
When you turn off your computer with fully charged batteries, the batteries
retain data for the following approximate time periods.
Extending battery life
To maximize the life of your battery pack:
■ At least once a month, disconnect the computer from a power source
and operate it on battery power until the battery pack fully discharges.
Before doing so, follow the steps below.
■ If you have extra battery packs, rotate their use.
■ If you will not be using the system for an extended period, more than
one month, remove the battery pack.
■ Disconnect the AC adaptor when the battery is fully charged.
Overcharging makes the battery hot and shortens life.
■ If you are not going to use the computer for more than eight hours,
disconnect the AC adaptor.
■ Store spare battery packs in a cool dry place out of direct sunlight.
High Capacity battery pack (8800mAh) about 5 days (Standby Mode)
about 55 days (Boot mode)
Battery pack (4400mAh) about 3 days (Standby Mode)
about 25 days (Boot mode)
RTC battery 30 days
1. Turn off the computer’s power.
2. Disconnect the AC adaptor and turn on the computer’s power. If it
does not turn on go to step 4.
3. Operate the computer on battery power for five minutes. If the
battery pack has at least five minutes of operating time, continue
operating until the battery pack is fully discharged. If the Battery
indicator flashes or there is some other warning to indicate a low
battery, go to step 4.
4. Connect the AC adaptor to the computer and the power cord to a
power outlet. The DC IN 15V indicator should glow green, and the
Battery indicator should glow orange to indicate that the battery
pack is being charged. If the DC IN 15V indicator does not glow,
power is not being supplied. Check the connections for the AC
adaptor and power cord.
5. Charge the battery pack until the Battery indicator glows green.