Starting the computer by password, Power-up modes, Windows utilities – Toshiba Tecra A2 User Manual
Page 114: Hot keys, Windows utilities -16 hot keys -16
User’s Manual
6-16
Power and Power-Up Modes
Starting the computer by password
To start up the computer with the user password, follow these steps:
1. Turn on the power as described in Chapter 3, Getting Started.
The following message appears:
S
Password
=
2. Enter the password.
3. Press Enter.
Power-up modes
The computer has the following power-up modes:
■
Boot: Computer shuts down without saving data. Always save your
work before you turn the computer off in boot mode.
■
Hibernation: Data in memory is saved to the hard disk.
■
Standby: Data is maintained in the computer’s main memory.
Windows utilities
You can specify the setting in TOSHIBA Power Saver.
Hot keys
You can use hot keys Fn + F3 to enter Standby Mode and Fn + F4 to enter
Hibernation Mode. Refer to Chapter 5,
for details.
At this point, the hotkeys Fn + F1 to F9 do not work. They will function after
you enter the password.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
Refer also to the sections
in Chapter 3, Getting Started.