Monitor, I.link (ieee1394) – Toshiba Tecra A5 User Manual
Page 156
TOSHIBA A5 9-17
Troubleshooting
Monitor
Refer also to Chapter 8,
, and to your monitor’s
documentation.
i.LINK (IEEE1394)
Problem
Procedure
Monitor does not turn
on
Make sure that the external monitor's power
switch is on. Confirm that the external monitor's
power cable is plugged into a working power
outlet.
No display
Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display
priority and make sure it is not set for the internal
display.
Display error occurs
Check that the cable connecting the external
monitor to the computer is attached firmly.
If problems persist, contact your dealer.
Monitor goes into
panning mode
Check your monitor specification. It might not
support the selected resolution and refresh rate.
The resolution on the monitor might go into
panning mode when wide screen resolution is
selected. Refer to Appendix B,
.
Problem
Procedure
i.LINK device does not
function
Make sure the cable is securely connected to the
computer and to the device.
Make sure the device's power is turned on.
Reinstall the drivers. Open the Windows Control
Panel and double-click the Add New Hardware
icon. Follow the on-screen directions.
Restart Windows.
If problems persist, contact your dealer.