Toshiba Satellite Pro M50 - Manual (Page 67)

User’s Manual 4-6
Operating Basics
LAN
The computer is equipped with networking hardware that supports Ethernet
LAN (10megabits per second, 10BASE-T) and Fast Ethernet LAN (100
megabits per second, 100BASE-TX). This section describes how to
connect/disconnect to a LAN.
Connecting the LAN cable
If you are using Ethernet LAN (10 megabits per second, 10BASE-T), you
can connect using either a CAT5 or a CAT3 cable.
If you are using 100BASE-TX Fast Ethernet, you must connect using a
CAT5 cable.
To connect the LAN cable, follow the steps below.
1. Turn off the power to the computer and to all external devices
connected to the computer.
2. Plug one end of the cable into the LAN jack. Press gently until you hear
the latch click into place.
Connecting the LAN cable
3. Plug the other end of the cable into a LAN hub connector. Check with
your LAN administrator before connecting to a hub.
Do not install or remove an optional memory module while the Wake-up on
LAN feature is enabled.
The Wake-up on LAN feature does not work on battery power, you should
always leave the computer connected to the AC adapter if you are using
this feature.
The computer must be configured properly before connecting to a LAN.
Logging onto a LAN using the computer's default settings could cause a
malfunction in LAN operation. Check with your LAN administrator
regarding set-up procedures.