BOXLIGHT CD-40m - Manual (Page 19)

12
S e t t i n g u p t h e P r o j e c t o r
Turning Off the Projector
If you want to turn off the projector for a short period of time,
press the
standby button on the keypad. This blanks the screen for
fifteen minutes, but keeps the projector running. (You can change
the amount of time the projector stays in standby mode; see
“Standby Time” on page 23 for details.) After 15 minutes, the
lamp goes out (the projector keeps running). To exit standby
mode, press the
standby button again. (It may take several sec-
onds for the projection lamp to reach full power and project the
image again.)
To completely power off the projector, press the “O” side of the
power switch on the side of the projector. If you want to turn the
projector back on immediately, you must allow about a minute
for the lamp to cool. The lamp won’t light if it’s too hot.
CAUTION: When you
disconnect the projector after you
have switched it off, always
remove the power cord from the
electrical outlet first, then remove
it from the projector.