Behringer MIC100 - Manual (Page 6)

6
TUBE ULTRAGAIN MIC100
If your MIC100 is connected to the mains via the enclosed
power supply unit, the POWER LED lights up to indicate that
your MIC100 is running.
The 20 dB PAD button reduces the input sensitivity by 20 dB.
The appropriate setting depends on the equipment connected.
No matter what your application is, the clip LED warns you to
reduce the gain setting, so as to avoid distortion.
This +48 V switch activates the phantom power supply for the
XLR input. Phantom power supply is required for operating
condenser microphones.
With the PHASE REVERSE switch, the input signal is reversed
by 180°. This function is available for both mic and line signals.
Use this function in a multi-microphone setup if you detect
phase cancellations in specific frequency bands.
Use the LIMITER switch to limit the signal and to prevent
distortion.
The OUTPUT control governs the output level of the device
within a range from -oo to +10 dB. If the control is set fully
counter-clockwise, there is no output signal at all. The more the
control is set clockwise, the higher the output level.
2.3 Serial number
The MIC100’s serial number is located on the bottom cover. Please
take time to fill in and return the warranty card within 14 days after the
date of purchase, so as to benefit from our extended warranty. Or
use our online registration option available on the World Wide Web at
www.behringer.com.
3. WIRING EXAMPLES
You’ll be surprised how flexibly you can set up your MIC100. The
following chapter describes some typical wiring examples.
3. WIRING EXAMPLES