Behringer MIC100 - Manual (Page 4)

4
TUBE ULTRAGAIN MIC100
2. CONTROL ELEMENTS
Fig. 2.1: Side panel of the MIC100
2.1 Connections (side panel)
Use the POWER SUPPLY CONNECTOR to hook up the enclosed
power supply unit. Next to this connector you’ll find the strain
relief clamp, which prevents accidental release of the power
supply.
This is the balanced XLR OUTPUT of your MIC100. Use this
connector to feed the XLR input of your mixing console,
multitrack recorder or power amp.
The balanced 1/4" TRS OUTPUT of your MIC100 can also be
connected to either mixer, recording system or power amp.
+
Please note that you can use the XLR and TRS outputs of
your MIC100 at the same time! Thus, it is possible to
connect the MIC100’s output signal to two different devices
simultaneously.
The balanced 1/4" TRS INPUT of your MIC100 can be used to
connect your electric guitar, for example. This input is wired
parallelly to the XLR input.
2. CONTROL ELEMENTS