Bosch Nexxt 500 Plus Series - Manual (Page 18)

18
Acoustic Signal
An acoustic signal indicates program
statuses (e.g. start/end of program and
operating faults.)
To activate the signal:
q
Select a program.
q Press two of the Option Buttons
(e.g. Stain Removal and Rinse
Plus) until a long signal is emitted.
To deactivate the signal:
q
Select a program.
q Press two of the Option Buttons
and hold until a short signal is
emitted.
i Do not activate/deactivate the
acoustic signal during a cycle.
Indicator light above the
Start/Pause" button
The indicator light conveys the
following information:
-
Indicator light flashing red:
Program can be started.
- Adding laundry is possible.
- Indicator light is lit red. Program is
running.
- Adding laundry is not possible
because the door is locked for
safety reasons.
Laundry may be added after pressing
the Start/Pause button.
Special features
Auto Load adjust
Auto Load adjust" adjusts the water
and energy consumption for each
program and determines the amount of
laundry and type of fabrics.
This process is built into your machine
and occurs automatically.
This control reduces water and energy
consumption when washing small
loads.
Unbalanced load detection system
The automatic unbalanced load
detection system spins the laundry
several times to ensure even
distribution.
If the wash load is unevenly distributed,
it will not spin (for safety reasons) or the
final spin speed is reduced.
In the wool program the appliance will
attempt to start the spin cycle only
twice in order to prevent shrinking.
Displayed Time
Due to these and other characteristics
of the controls the actual cycle time will
vary.
When a program has been selected,
the expected program duration is
displayed.
The following variables will effect the
displayed time:
- Load size
- Repeated spin attempts to evenly
distributed load
- Additional rinse cycles if excessive
foam occurs
- Water pressure is too low
- Selection of additional options,
e.g. Rinse plus"
i Each item listed above can
potentially increase time
requirements for a selected wash
program. The initial program
required time will adjust for these
variables. The displayed time will
count down until the end of the
cycle.
Washing
q Turn on the water taps.
q Turn the program selector to the
desired program.
q Load the washing machine and
close the door.
The Start/Pause indicator light
flashes (red).
q If necessary, press the button(s) for
additional option(s).
The indicator light of the selected
button is lit (red).
i If an incorrect combination was
inadvertently selected, the
indicator light of the selected
button is turned off.
q If necessary, change the spin
speed with the Spin selection
button until the the desired spin
speed indicator light is lit.
q If necessary, change the Start
time. Press the Delay Start button
until the desired Start time is
displayed.