Bosch Nexxt 500 Plus Series - Manual (Page 11)

11
q Turning the foot out (clockwise)
will raise the corner of the
washer, turning the foot in
(counter-clockwise) will lower
the corner of the washer.
When the corner of the washer
is satisfactorily raised or
lowered, lock the
height-adjustable feet in place
by turning the lock nut
counter-clockwise until it locks
tightly against the washer
housing.
i It may be necessary to hold
the washer foot with a pair
of pliers to keep it from
turning while tightening the
lock nut. It the foot does
turn, it will change the
height of the corner.
q After making preliminary
adjustments, press down on
each corner of the washer to
make sure the unit does not
wobble. If it does wobble,
lower the foot on that corner
until the foot touches the floor
firmly.
4. Re-check the leveling status of the
appliance.
5. Fine tune the leveling of your
washer by checking with a bubble
level after running your first load of
laundry. This is a very important
step.
Transport, such as when
moving out
Before transporting the washing
machine:
-
Turn off the water.
- Disconnect the washing machine
from the power outlet.
- Dismantle the supply and drainage
hoses.
- Install the transport bolts.
Preparing and inserting the
transport bolts
q Remove the covers.
q Prepare the transport bolts:
Loosen the screw in the sleeve
until the end of the screw is level
with the end of the sleeve.
q Insert and tighten all transport
bolts. Make sure that the tab on
the transportation bolt is inserted
in the slot on the washing machine
back panel.