Pioneer AVH-P7900DVD - Manual (Page 90)

! You can store the adjusted setting in memory
by using MEMORY. For details concerning op-
eration, refer to Storing the adjusted audio set-
tings in memory on page 94.
Using the cut-off frequency
You can adjust the cut-off frequency and slope
to match the characteristics of each speaker
unit. And then you can store the adjusted cut-
off frequency in this unit for later recall.
Recalling cut-off frequency
settings
% Touch CUT OFF on the sound setting
menu to select the cut-off frequency set-
ting.
Touch
CUT OFF repeatedly to switch between
the following cut-off frequency settings:
CUSTOM1
—CUSTOM2—CUSTOM3—AUTO
—LAST MEMORY
# You can select LAST MEMORY only when the
adjusted cut-off frequency setting is not memor-
ized in this unit.
# You cannot select AUTO when NETWORK
has been selected. (Refer to Switching the DSP
setting mode on page 108.)
# When STANDARD has been selected, you
cannot select
AUTO if auto TA and EQ has not
been carried out.
Selecting a cut-off frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
SMALL, you can select a
frequency, under which sounds are repro-
duced through a
LARGE speaker or subwoo-
fer.
1 Recall the cut-off frequency setting you
want to adjust.
Refer to Recalling cut-off frequency settings on
this page.
2 Touch ADJ. next to CUT OFF on the
sound setting menu.
3 Touch the speaker to be adjusted.
# You cannot select speakers whose size is set
at
OFF or LARGE.
4 Touch or to adjust parameters of
the selected speaker unit (filter).
Adjustable parameters and ranges are differ-
ent depending on each speaker unit (filter).
Parameter What it does
FREQUENCY
Selects cut-off frequencies in the fol-
lowing order:
50
—63—80—100—125—160—
200 (Hz)
SLOPE
Selects slopes in the following order:
–18— –12— –6 (dB/oct.)
When subwoofer is selected
Parameter What it does
FREQUENCY
Selects cut-off frequencies in the fol-
lowing order:
50
—63—80—100—125—160—
200 (Hz)
SLOPE
Selects slopes in the following order:
–18— –12— –6—0 (pass) (dB/oct.)
PHASE
Switches the phase between NOR-
MAL and REVERSE.
Audio Adjustments
En
90
Section
17