Pioneer AVH-P7900DVD - Manual (Page 118)

Message Cause Action (See)
ERROR-02-XX Dirty disc Clean disc.
Scratched disc Replace disc.
The disc is loaded upside down Check that the disc is loaded correctly.
Electrical or mechanical Press RESET.
DIFFERENT REGION DISC (RE-
GION ERR) The disc does not have the same re-
gion number as this unit Replace the DVD video with one bearing the
correct region number.
NON-PLAYABLE DISC (NON-
PLAY) This type of disc cannot be played
by this unit Replace the disc with one this unit can play.
The inserted disc does not contain
any files that can be played back Replace disc.
NON-PLAYABLE FILE (NON-
PLAY) The inserted disc contains DivX
video files that cannot be played by
this unit. ! Switch to the other file that can be played
by this unit.
! Replace disc.
THERMAL PROTECTION IN
MOTION (TEMP) The temperature of this unit is out-
side the normal operating range Wait until the unit
’s temperature returns to
within normal operating limits.
FILE Skipped The inserted disc contains WMA
files that are protected by DRM ! Play an audio file not protected by DRM.
! Replace disc.
PROTECT All the files on the inserted disc are
secured by DRM Replace disc.
Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message Cause Action
Error. Please check MIC. Microphone is not connected. Plug the supplied microphone securely into
the jack.
Error. Please check front SP.,
Error. Please check FL SP.,
Error. Please check FR SP.,
Error. Please check center SP.,
Error. Please check rear SP.,
Error. Please check RL SP.,
Error. Please check RR SP.,
Error. Please check rear center
SP., Error. Please check sub-
woofer. The microphone cannot pick up the
measuring tone of a speaker. ! Confirm that the speakers are connected
correctly.
! Correct the input level setting of the power
amp connected to the speakers.
! Set the microphone correctly.
Additional Information
En
118
Appendix