Pioneer AVH-P4000DVD - Manual (Page 18)

Note
Listening MW radio while an iPod is charged
from this unit may generate noise. In this case,
turn the iPod charge setting off and noise is dis-
appeared. (Refer to Switching the iPod charge set-
ting on page 47.)
Storing and recalling broadcast
frequencies
You can easily store up to six broadcast fre-
quencies for later recall.
! Up to 18 FM stations, six for each of the
three FM bands, and six MW/LW stations
can be stored in memory.
1 Touch LIST to display the preset list.
2 When you find a frequency that you
want to store in memory keep touching
one of preset tuning keys P1 to P6 until the
beep sounds.
The selected radio station frequency has been
stored in memory.
The next time you touch the same preset tun-
ing key the radio station frequency is recalled
from memory.
3 Touch ESC to return to the ordinary dis-
play.
Note
You can also use a and b to recall radio station
frequencies assigned to preset tuning keys
P1 to
P6.
Introduction of advanced
operations
1 Touch AV MENU and then touch
FUNCTION MENU to display the function
names.
The function names are displayed and oper-
able ones are highlighted.
2 Touch ESC to return to the frequency
display.
# To return to the previous display, touch BACK.
Storing the strongest broadcast
frequencies
BSM (best stations memory) lets you automa-
tically store the six strongest broadcast fre-
quencies under preset tuning keys
P1 to P6
and once stored there you can tune in to those
frequencies with the touch of a key.
! Storing broadcast frequencies with BSM
may replace broadcast frequencies you
have saved using
P1 to P6.
% Touch BSM on the function menu to
turn BSM on.
BSM begins to flash. While BSM is flashing
the six strongest broadcast frequencies will be
stored under preset tuning keys
P1 to P6 in
order of their signal strength. When finished,
BSM stops flashing.
# To cancel the storage process, touch BSM
again.
Tuning in strong signals
Local seek tuning lets you tune in only those
radio stations with sufficiently strong signals
for good reception.
% Touch LOCAL on the function menu to
set the sensitivity.
Touch
LOCAL repeatedly until the desired level
of sensitivity appears in the display.
There are four levels of sensitivity for FM and
two levels for MW/LW:
FM:
OFF
—LEVEL1—LEVEL2—LEVEL3—
LEVEL4
MW/LW:
OFF
—LEVEL1—LEVEL2
The LEVEL4 setting allows reception of only
the strongest stations, while lower settings let
you receive progressively weaker stations.
Operating this unit
En
18
Section
03