Pioneer AVIC-HD1BT - Manual (Page 10)

9
Connecting the System
Connecting the power cord (1)
Connect leads of the same
colour to each other.
C a p ( * 1 )
When not using this terminal,
do not remove the cap.
ISO connector
Fuse (10 A)
*1
*2
*4
*3
*5
Yellow (*2)
To terminal always supplied
with power regardless of
ignition switch position.
Red (*4)
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.
Yellow (*3)
Back-up
(or accessory)
Red (*5)
Accessory
(or back-up)
Black (earth)
To vehicle (metal) body.
Orange/white
To lighting switch terminal.
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
Note:
Depending on the kind of vehicle, the
function of *3 and *5 may be different.
In this case, be sure to connect *2 to *5
and *4 to *3.
Speaker leads
White:
Front left +
White/black: Front left ≠
Grey:
Front right +
Grey/black: Front right ≠
Green: Rear left + or Subwoofer + (*9)
Green/black: Rear left ≠ or Subwoofer ≠ (*9)
Violet:
Rear right + or Subwoofer + (*9)
Violet/black: Rear right ≠ or Subwoofer ≠ (*9)
Yellow/black
If the vehicle can send a mute signal to this terminal,
the mute function can be activated on this navigation
system when the terminal is connected to *8.
Note:
When a subwoofer (*9) is connected to this naviga-
tion system instead of a rear speaker, change the
rear output setting in the Initial Setting. (Refer to
the Operation Manual.) The subwoofer output of
this navigation system is monaural.
When replacing the fuse, be sure to only use a
fuse of the rating prescribed on the fuse holder.