Switching the auxiliary setting 96, Controller 96, Switching the auxiliary setting – Pioneer AVH-P6600DVD User Manual

Page 96: Selecting the illumination color, Setting the rear output and subwoofer controller, Initialsettings

1 Touch A.MENU and INITIAL and then

touch DETACH WARNING.

2 Touch a to turn warning tone on.

# To turn warning tone off, touch b.

Switching the auxiliary setting

It is possible to use auxiliary equipment with

this unit. Activate the auxiliary setting when

using auxiliary equipment connected to this

unit.

1 Touch A.MENU and INITIAL and then

touch AUX.

2 Touch a to turn auxiliary setting on.

# To turn auxiliary setting off, touch b.

Selecting the illumination

color

This unit is equipped with two illumination col-

ors, green and red. You can select the desired

illumination color.

1 Touch A.MENU and INITIAL and then

touch ILLUMINATION.

2 Touch a or b to select the desired illu-

mination color.

Touch a to select GREEN (green). Touch b to

select RED (red).

Setting the rear output and

subwoofer controller

This units rear output (rear speaker leads out-

put and RCA rear output) can be used for full-

range speaker (FULL) or subwoofer (SUB. W)

connection. If you switch the rear output set-

ting to the SUB. W, you can connect a rear

speaker lead directly to a subwoofer without

using an auxiliary amp.

Initially, the unit is set for rear full-range speak-

er connection (FULL). When rear output is

connected to full range speakers (when FULL

is selected), you can connect the RCA sub-

woofer output to a subwoofer. In this case, you

can select whether to use the subwoofer con-

trollers (low pass filter, phase) built-in SUB.W

or the auxiliary FULL.

! When the multi-channel processor (e.g.,

DEQ-P6600) is connected to this unit, you

cannot operate this function.

1 Touch A.MENU and INITIAL and then

touch REAR SPEAKER.

2 Touch

to switch the rear out-

put setting.

Touch

to select full-range speaker and

FULL appears in the display. Touch

to select

subwoofer and SUB. W appears in the display.

# When no subwoofer is connected to the rear
output, select FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer SUB. W.
# When the rear output setting is SUB. W, you
cannot change the subwoofer controller.

3 Touch

to switch the subwoofer

output or non fading output.

Touch

to select subwoofer output and

SUB.W appears in the display. Touch

to se-

lect non fading output and FULL appears in

the display.

Notes

! Even if you change this setting, there is no

output unless you turn the nonfading output
(refer to Using nonfading output on page 75)

InitialSettings

Section