Pioneer AVH-P6600DVD - Manual (Page 95)

Adjusting initialsettings
1
Initial settings lets you perform initial setup of
different settings for this unit.
1 Function display
Shows the function names.
1 Touch the source icon and then touch
OFF to turn this unit off.
# When the source icon is not displayed, you
can display it by touching the screen.
2 Touch A.MENU and then touch INITIAL
to display the function names.
The function names are displayed and oper-
able ones are highlighted.
# When A.MENU is not displayed, you can dis-
play it by touching the screen.
# You can also display MENU by clicking the
joystick.
# To go to the next group of function names,
touch NEXT.
# To return to the previous group of function
names, touch PREV.
# When the multi-channel processor (e.g., DEQ-
P6600) is connected to this unit, you can operate
DIGITAL ATT instead of REAR SPEAKER.
# To return to the previous display, touch BACK.
# To return to the display of each source, touch
ESC.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1 Touch A.MENU and INITIAL and then
touch FM STEP.
2 Touch c or d to select the FM tuning
step.
Touching c or d will switch the FM tuning
step between 50 kHz and 100 kHz while AF or
TA is on. The selected FM tuning step will ap-
pear in the display.
Note
The tuning step remains at 50 kHz during manual
tuning.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Touch A.MENU and INITIAL and then
touch AUTO PI.
2 Touch a to turn Auto PI Seek on.
# To turn Auto PI Seek off, touch b.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
InitialSettings
En
95
Section
18
InitialSettings