Pioneer AVH-P4200DVD - Manual (Page 80)

Message Cause Action
Unplayable
File This type of file
cannot be played
on this unit. Select a file that
can be played.
Format Read Sometimes there
is a delay be-
tween the start of
playback and
when you start to
hear any sound. Wait until the mes-
sage disappears
and you hear
sound.
Video frame
rate not sup-
ported. DivX file ’s frame
rate is more than
30 fps.
Select a file that
can be played.
Audio format
not sup-
ported. This type of file is
not supported on
this unit. Select a file that
can be played.
iPod
Message Cause Action
Format Read/
Ready Sometimes there
is a delay be-
tween the start of
playback and
when you start to
hear any sound. Wait until the mes-
sage disappears
and you hear
sound.
Error-02-6X/-
9X/-DX Communication
failed. Disconnect the
cable from the
iPod. Once the
iPod's main menu
is displayed, recon-
nect the iPod and
reset it.
iPod failure Disconnect the
cable from the
iPod. Once the
iPod's main menu
is displayed, recon-
nect the iPod and
reset it.
Error-02-67 The iPod firm-
ware versions are
old. Update the iPod
version.
Stop There are no
songs. Transfer songs to
the iPod.
There are no
songs in the cur-
rent list. Select a list that
contains songs.
Bluetooth
Message Cause Action
Error-10 The power failed
for the Bluetooth
module of this
unit. Turn the ignition
switch OFF and
then to ACC or ON.
If the error mes-
sage is still dis-
played after
performing the
above action,
please contact
your dealer or an
authorized Pioneer
Service Station.
Understanding auto EQ/
auto TA and EQ error
messages
When correct measurement of the car
’s inter-
ior acoustic characteristics is not possible
using auto TA and EQ, an error message may
appear on the display. In such cases, refer to
the table below to see what the problem is and
how it may be corrected. After checking, try
again.
Message Cause Action
Error. Please
check MIC. The microphone
is not connected. Plug the optional
microphone se-
curely into the
jack.
Error. Please
check xxxx
speaker.,
Error. Please
check Sub-
woofer. The microphone
cannot pick up
the measuring
tone of a speaker. ! Confirm that the
speakers are con-
nected correctly.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Plug the micro-
phone securely
into the jack.
En
80
Appendix
Additional Information