Pioneer AVH-P4200DVD - Manual (Page 64)

3 Touch Rear Speaker on the system
menu to switch the subwoofer output or
full-range speaker.
# When no subwoofer is connected to the rear
output, select
Full (full-range speaker).
# When a subwoofer is connected to the rear
output, select
Subwoofer (subwoofer).
# When the rear output setting is Subwoofer,
you cannot operate the following procedure.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
47).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Setting the FM tuning step
Normally, the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
! The tuning step remains at 50 kHz during
manual tuning.
1 Select the Radio source.
Refer to Basic Operations on page 9.
2 Display the system menu.
Refer to Introduction of menu operations on
page 45.
3 Touch FM Step on the system menu to
select the FM tuning step.
Touching
FM Step will switch the FM tuning
step between 50 kHz and 100 kHz. The se-
lected FM tuning step will appear.
RDS setting
Limiting stations to regional
programming
When AF is used, the regional function limits
the selection of stations to those broadcasting
regional programs.
1 Select the Radio source.
Refer to Basic Operations on page 9.
2 Display the system menu.
Refer to Introduction of menu operations on
page 45.
3 Touch RDS Setup on the system menu.
4 Touch Regional on the function menu
to turn the regional function on.
# To turn the regional function off, touch
Regional again.
Selecting alternative frequencies
When the tuner cannot get a good reception,
the unit automatically searches for a different
station in the same network.
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch RDS Setup on the system menu.
3 Touch Alternative FREQ to turn AF on.
# To turn AF off, touch Alternative FREQ again.
Note
Sound may be temporarily interrupted by another
program during an AF frequency search.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Turn the unit off.
Refer to Basic Operations on page 9.
En
64
Section
13 Menu operations