Pioneer FH-P80BT - Manual (Page 9)

9
English
Rubber bush
Double-ended screw
Screw (3 × 6 mm)
Dashboard
Installation
2. Install this unit and fasten the screws.
3. Attach the trim ring.
Installation using the screw
holes on the side of the unit
1. Remove the side brackets.
2. Fastening the unit to the factory
radio-mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket,
and tighten the screws at 3 or 4 locations on
each side.
Note
In some types of vehicles, discrepancy may
occur between the unit and the dashboard. If this
happens, use the supplied frame to fill the gap.
Trim ring
Side bracket
Screw for fixing the side
bracket (5 × 8 mm)
Factory radio
mounting bracket
If the pawl gets in the way,
bend it down.
Dashboard or console
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this unit.