Pioneer AVH-P4000DVD - Manual (Page 79)

Problems during iPod playback
Symptom Cause Action
iPod doesn
’t operate correctly.
Cables are incorrectly connected. Disconnect the cable from iPod. Once iPod
main menu is displayed, connect the cable
again.
Reset the iPod.
The iPod version is old. Update the iPod version.
Problems during multi-channel processor connection
Symptom Cause Action (See)
No sounds are heard.
The volume level will not rise. Optical cables are not connected
correctly. Connect the cables correctly.
Even if multi-channel audio is
selected, 2-channel audio is out-
put. Digital output setting is set to Line-
ar PCM.
Normally, set the digital output setting to
STREAM. (Page 41)
Error messages
When you contact your dealer or your nearest Pioneer Service Center, be sure to have the error
message recorded.
Built-in DVD player
Message Cause Action
DIFFERENT REGION DISC The disc does not have the same re-
gion number as this unit Replace the DVD video with one bearing the
correct region number.
ERROR-02-XX Dirty disc Clean disc.
Scratched disc Replace disc.
The disc is loaded upside down Check that the disc is loaded correctly.
Electrical or mechanical Press RESET.
NON-PLAYABLE DISC This type of disc cannot be played
by this unit Replace the disc with one this unit can play.
The inserted disc does not contain
any files that can be played back Replace disc.
PROTECT All the files on the inserted disc are
secured by DRM Replace disc.
SKIPPED The inserted disc contains WMA
files that are protected by DRM Replace disc.
TEMP The temperature of this unit is out-
side the normal operating range Wait until the unit
’s temperature returns to
within normal operating limits.
Additional Information
En
79
Appendix
Additional
Information