BT 1015 EN - Manual (Page 33)

31
Baby Alarm
The baby alarm sets up a
connection between two
telephones registered to the
same base. When a noise
registers in the first telephone,
the second one rings. If the
call to the second telephone is
answered, conversation is
possible. The standard setting
for this service is OFF.
The standard setting for the
sensitivity level of this alarm
is
2 . If you wish to change the
sensitivity, see page 25.
The baby alarm will not work
in conjunction with call barring.
If one of the telephones you
are using requires batteries,
they must be fully charged
and the handset in the ‘baby
room’ must not be placed in a
charger, as this will cover the
microphone.
Press the MENU button.
Select PHONE LOCK and press OK .
CODE
Enter PIN (default 0000) and
press
OK .
Use UP or DOWN to select
DSS NUMBER from the menu and
press OK .
Use the RIGHT / LEFT and
DELETE buttons to change the
number (or just use the DELETE
button to remove the complete
number if you wish to cancel the
stored Quickdial number).
Press ACTIVATE once you have
finished your alterations.
Press OK to save entry.
KEYPAD
In case of emergencies, you can
still dial
999 , even if the phone
lock has been activated. To do
this the handset must be on the
cradle. First dial
999 and then
pick up the handset. If you are
calling via a switchboard, you
will need to dial the switchboard
external dialling code (usually
0 , 9 or R ) before the 999
O K
+
➞
O K
▼
▲
O K
O K
ᮣ
To edit or cancel a stored
Quickdial number
To switch the baby alarm
ON and OFF
To contact emergency services
when outgoing calls have been
blocked
ADDITIONAL FEA
TURES