Pioneer PDP-42RXE - Manual (Page 22)

06 Basic Operations
22
En
Using the multiscreen functions
You can display a sub-picture within the main picture. In this
way you can watch a TV programme or monitor the video input
from any connected device while watching TV or another video
input.
Use this function following the procedures below to select the
Twin (2-screen) or PIP (picture in picture) mode.
• In the multiscreen function, the sound of a main input is always
output.
PIP (picture in picture)
Main input Sub-picture
Twin 1 (2-screen)
Main input Sub-picture
Twin 2 (2-screen)
Main input Sub-picture
1 Press the MENU button.
2 Press the c or d button to move to Screen, then press
the \ or OK button.
3 Press the c or d button to move to PIP/TWIN, then
press the \ or OK button.
Screen
Screen Size Full
Main Input ANALOG CH
PIP/TWIN
AV1 Input VIDEO
AV2 Output ANALOG CH
Screen Saver
Move Enter Return
4 Select PIP/TWIN Mode and press the \ or OK button
again.
5 Press the c or d button to select the required option as
follows, then press the [ or the BACK button.
Off - PIP - TWIN1 - TWIN2
Off
PIP
TWIN1
TWIN2
PIP/TWIN
PIP/TWIN Mode PIP
PIP/TWIN Input AV1
PIP Position
Adjust Return
• If you set to Off, the following steps are not available.
6 Press the c or d button to move to PIP/TWIN Input,
then press the \ or OK button.
7 Press the c or d button to select the required input
source as follows, then press [ or the BACK button.
ANALOG CH - AV1 - AV2 - AV3 - S-VIDEO - VIDEO -
COMPONENT - HDMI
PIP/TWIN
PIP/TWIN Mode PIP
PIP/TWIN Input AV1
PIP Position
ANALOG CH
AV 1
AV 2
AV 3
S-VIDEO
VIDEO
COMPONENT
HDMI
Move Enter Cancel
• You can select the mode by simply pressing the button on
the remote control.
• You can select the source by simply pressing the button on
the remote control.
• In Twin or PIP mode, press the button to switch the position
of the 2-screen shown.
07-PDP42RXE-Eng (18-23) 9/30/05, 12:16 PM 22