Pioneer DEH-4600BT - Manual (Page 19)

LOUDNESS (loudness)
Loudness compensates for deficiencies in the low-fre-
quency and high-frequency ranges at low volume.
1 Press M.C. to select the desired setting.
OFF (off)
—LOW (low)—MID (mid)—HI (high)
SUB.W (subwoofer on/off setting)
This unit is equipped with a subwoofer output which
can be turned on or off.
1 Press M.C. to select the desired setting.
NOR (normal phase) —REV (reverse phase)—OFF
(subwoofer off)
SUB.W CTRL (subwoofer adjustment)
Only frequencies lower than those in the selected
range are outputted from the subwoofer.
1 Press M.C. to display the setting mode.
2 Press M.C. to cycle between the following:
Cut-off frequency —Output level—Slope level
Rates that can be adjusted will flash.
3 Turn M.C. to select the desired setting.
Cut-off frequency: 50HZ —63HZ—80HZ—100HZ
—125HZ—160HZ—200HZ
Output level:
–24 to +6
Slope level: –12— –24
BASS BOOST (bass boost)
1 Press M.C. to display the setting mode.
2 Turn M.C. to select a desired level.
0 to +6 is displayed as the level is increased or de-
creased.
HPF SETTING (high pass filter adjustment)
Use this function when wanting to listen only to high-
frequency sounds. Only frequencies higher than the
high-pass filter (HPF) cutoff are output from the
speakers.
1 Press M.C. to display the setting mode.
2 Press M.C. to cycle between the following:
Cut-off frequency
—Slope level
3 Turn M.C. to select the desired setting.
Cut-off frequency: OFF —50HZ—63HZ—80HZ—
100HZ —125HZ—160HZ—200HZ
Slope level: –12— –24
SLA (source level adjustment)
This function prevents the volume from changing too
dramatically when the source switches.
! Settings are based on the FM volume level, which
remains unchanged.
! The MW/LW volume level can also be adjusted
with this function.
! Each of the below combinations are set to the
same setting automatically.
! USB, iPod and APP (iPhone)
! BT AUDIO and APP (smartphone)
1 Press M.C. to display the setting mode.
2 Turn M.C. to adjust the source volume.
Adjustment range: +4 to –4
System menu
Important
PW SAVE (power saving) is canceled if the vehi-
cle battery is disconnected and will need to be
turned back on once the battery is reconnected.
When
PW SAVE (power saving) is off, depending
on connection methods, the unit may continue to
draw power from the battery if your vehicle
’s igni-
tion doesn
’t have an ACC (accessory) position.
1 Press M.C. to display the main menu.
2 Turn M.C. to change the menu option
and press to select SYSTEM.
3 Turn M.C. to select the system menu
function.
Once selected, the following system menu
functions can be adjusted.
! INFO DISPLAY and BRIGHTNESS are not
available for DEH-4600BT.
LANGUAGE (multi-language)
1 Turn M.C. to select the desired setting.
ENG (English) —РУС (Russian)—TUR (Turkish)
CLOCK SET (setting the clock)
En
19
Section
02
Using
this
unit
Using this unit