Pioneer VSX-920-K - Manual (Page 7)

7
Operations on the Receiver and USB Connections
In order to display the various data measured on the receiver on the computer’s screen, perform the
operations below to connect the USB device and transfer the receiver’s data.
1
Perform the “Full Auto MCACC” operation on the receiver. (See the receiver’s
Operating Instructions.)
The measurements here are not required if the “Full Auto MCACC” operation has already been
performed. Proceed to
step 2 .
2
Select “Output MCACC data” from “MCACC Data Check”. (See the receiver’s
Operating Instructions.)
The message “Please connect your USB memory for the MCACC data, then press OK to output them.”
appears on the monitor screen and the receiver enters the transmission standby mode. It is ready to
send data to your USB device. (The display screen may differ, depending on the receiver’s model.)
3
Connect your USB device to the USB terminal on the front panel, then select
“OK”.
(The illustration of the receiver may differ, depending on the receiver’s model.)
“Please wait...” will be displayed on the screen and transmission of measurement data to the USB
device will begin. Transmission is complete when “Complete” is displayed.
This completes the preparations for sending the measurement data to your USB device.
(To send the data, proceed to the next section Application Operations.)
a. Speaker Setting
b. Channel Level
c. Speaker Distance
2.MCACC Data Check
d. Standing Wave
e. Acoustic Cal EQ
f. Group Delay
g. Output MCACC data
A/V RECEIVER
Exit Return
Please connect your USB memory for the MCACC data,
then press OK to output them.
2g.Output MCACC data
Exit Cancel
A/V RECEIVER
OK
MASTER
VOLUME
MCACC
SETUP MIC
VIDEO CAMERA
iPod
iPhone
USB HDMI 5
Continue