Switching the auxiliary setting, Switching the dimmer setting, Adjusting the brightness – Pioneer DEH-P5100UB User Manual
Page 35: Setting the rear output and subwoofer, Controller, Setting the rear output and subwoofer controller, Initial settings

1
Use MULTI-CONTROL to select
Warning tone in the initial setting menu.
Refer to Adjusting initial settings on page 33.
2
Press MULTI-CONTROL to turn warning
tone on.
# To turn warning tone off, press
MULTI-CONTROL again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 38.
1
Use MULTI-CONTROL to select AUX1/
AUX2 in the initial setting menu.
Refer to Adjusting initial settings on page 33.
2
Press MULTI-CONTROL to turn AUX1/
AUX2 on.
# To turn AUX off, press MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
’s headlights are turned on. You
can turn the dimmer on or off.
1
Use MULTI-CONTROL to select Dimmer
in the initial setting menu.
Refer to Adjusting initial settings on page 33.
2
Press MULTI-CONTROL to turn dimmer
on.
# To turn dimmer off, press MULTI-CONTROL
again.
Adjusting the brightness
You can adjust the display brightness.
1
Use MULTI-CONTROL to select
Brightness in the initial setting menu.
Refer to Adjusting initial settings on page 33.
2
Push MULTI-CONTROL left or right to
adjust the brightness level.
0 to 15 is displayed as the level is increased or
decreased.
# When dimmer is functioning, the brightness
level can be adjusted
0 to 10.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Rear SP :F.Range) or subwoo-
fer (
Rear SP :S/W) connection. If you switch
the rear output setting to
Rear SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
Rear SP :F.Range).
1
Use MULTI-CONTROL to select
S/W control in the initial setting menu.
Refer to Adjusting initial settings on page 33.
2
Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL will switch be-
tween
Rear SP :F.Range (full-range speaker)
and
Rear SP :S/W (subwoofer) and that status
will be displayed.
# When no subwoofer is connected to the rear
output, select
Rear SP :F.Range (full-range speak-
er).
# When a subwoofer is connected to the rear
output, select
Rear SP :S/W (subwoofer).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
30).
Initial Settings
En
35
Section
04
Initial
Settings