Pioneer S-71W - Manual (Page 6)

6
En
PANEL FACILITIES
FRONT PANEL
REAR PANEL
1 Power Indicator (STANDBY/ON)
Lights blue when the power has been
switched ON. Lights red when the unit is in
the standby condition.
NOTE:
• The power is still supplied even when the
power indicator is off. The power plug
(interrupter) must be unplugged in order to
completely cut the power supply. When not
using this product for long periods of time,
such as when traveling, unplug the power
cord (interrupter) from the power outlet for
safety purposes. Failure to do so could lead
to fire.
2 Power switch (POWER)
Switches the subwoofer between ON and
OFF.
3 Volume knob (VOLUME)
Sets the subwoofer volume.
• Turn the knob slowly from the MIN
position.
• With this unit, the bass level can be
independently set, so do not turn up the
bass on the AV amplifier.
4 Auto Standby switch (AUTO STANDBY)
Turning the Auto Standby function on or
off.
NOTE:
• The default setting for Auto Standby switch
is ON.
Auto standby function
The power is automatically set to the standby
mode (off) if there is no input signal for
approximately 12 minutes (the power
indicator turns red). The power automatically
turns on when a signal is input. The auto
standby function is deactivated when Auto
Standby switch is set to OFF.
NOTE:
• There may be cases where a connected
component outputs noise or some other
non-audio signal which causes this system
to automatically power on when in Auto
Standby mode. If this happens, switch off
the Auto Standby mode and switch the
system on/off manually.
5 Phase switch (PHASE)
When set to 180 ° , the output phase
becomes the reverse of the input signal,
and when set to 0
° , it is in the same phase
as the input signal.
• Normally, the switch is set to 0
° .
But when the sound connection
between the subwoofer and the left and
right speakers sounds unnatural, try
switching to 180
° and set the switch in
the position where the sound is natural.
6 Line Level Output terminal (LINE OUT)
Used for connecting other equipment
through the amplifier. The signal output
from this jack is not affected in any way by
the settings of the variouscontrols on the
unit.
7 Line Level Input terminal (LINE IN)
Connect to the SUBWOOFER PREOUT
terminal of an amplifier or receiver, with the
specially provided RCA plug cord.
8 AC IN
• Connect the power cord to the powered
subwoofer unit’s AC IN.
• Connect the power cord to an AC socket.
1
STANDBY/ON
3
5
4
7
2
8
6
[email protected] 6 ページ ２００９年９月１１日 金曜日 午後４時４８分