26 customising preferences – Pioneer AVIC-F930BT User Manual
Page 146
— Microphone for acoustical measure-
ment (sold separately)
— Low battery
Performing Auto EQ
p Auto EQ changes the audio settings as fol-
lows:
! “Auto EQ” on the “EQ Menu” screen is
set to
“On”.
= For details, refer to Using the auto-ad-
! The fader/balance settings return to the
centre position.
= For details, refer to Using balance ad-
! The equaliser curve switches to “Flat”.
= For details, refer to Using the equali-
! The front and rear speakers will automa-
tically be adjusted to a high pass filter
setting.
p Previous settings for Auto EQ will be over-
written.
1
Stop the vehicle in a place that is quiet,
close all the doors, windows and sun roof,
and then turn the engine off.
If the engine is left running, engine noise may
prevent correct Auto EQ.
p If driving restrictions are detected during
measurement, measurement is cancelled.
2
Fix the microphone for acoustical mea-
surement (sold separately) in the centre of
the headrest of the driver
’s seat, facing for-
ward.
The Auto EQ may differ depending on where
you place the microphone. If desired, place
the microphone on the front passenger seat
and perform Auto EQ.
3
Turn the ignition switch to ON or ACC.
If the vehicle
’s air conditioner or heater is
turned on, turn it off. Noise from the fan in the
air conditioner or heater may prevent correct
Auto EQ.
4
Turn off the AV source.
= For details of the operations, refer to Dis-
playing the AV operation screen on page 61.
5
Display the
“AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 138.
6
Touch [Auto EQ Meas.].
The
“Auto EQ Measurement” screen ap-
pears.
7
Plug the microphone into the mini-jack
connector.
USB and mini-jack connector
Microphone for acoustical measurement (sold separately)
8
Touch [Start].
A 10-second countdown starts.
Engb
146
Chapter
26
Customising preferences