Pioneer AVIC-F930BT - Manual (Page 140)

p Remember that use of this system for com-
mercial or public viewing purposes may
constitute an infringement on the author
’s
rights protected by the Copyright Law.
p The navigation map and the rear view cam-
era picture is always viewed at
“Full”.
Setting the rear output
The navigation system
’s rear output can be
used for a full-range speaker or subwoofer
connection. If you switch
“Rear SP” to
“Sub. W”, you can connect a rear speaker lead
directly to a subwoofer without using an auxili-
ary amp.
Initially, the navigation system is set for a rear
full-range speaker connection (
“Full”).
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)
p “Rear SP” can be set only when the source
is selected to
“Off”.
1 Display the
“AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 138.
2 Touch [Rear SP].
Each touch of [ Rear SP] changes the settings
as follows:
! Full
When no subwoofer is connected to the
rear output, select
“Full”.
! Sub. W
When a subwoofer is connected to the rear
output, select
“Sub. W”.
Switching the muting/
attenuation timing
You can mute the AV source volume or attenu-
ate the output signal.
p Even if this setting is “Off”, the navigation
system will mute or attenuate the AV
source volume when the mute signal is out-
put via MUTE lead.
1 Display the “AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 138.
2 Touch [Mute].
Each touch of [ Mute] changes the settings as
follows:
! Guide/Tel: The volume is muted or attenu-
ated according to the following conditions.
— When the navigation outputs the gui-
dance voice.
— When you use a mobile phone via
Bluetooth technology (dialling, talking,
incoming call).
! Tel: The volume is muted or attenuated
when you use a mobile phone via Bluetooth
technology (dialling, talking, incoming call).
! Off: The volume does not change.
p AV source volume returns to normal when
the corresponding action ends.
Engb
140
Chapter
26 Customising preferences