Pioneer PDP-506FDE - Manual (Page 20)

20
En
Preparation 05
Basic connections
Connecting to an antenna
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used
for a coaxial cable.
Antenna cable (commercially available)
Connecting the power cord
Plasma Display (rear view)
NOTE
• Disconnect the power cord from the power outlet, Plasma Display and Media Receiver when the system is not going to be used
for a long period of time.
ANT
INPUT 2
INPUT 1
SERVICE ONLY
INPUT
I /o link.A SELECT
INPUT 2
INPUT 3 HDMI SYSTEM CABLE BLACK WHITE
COMPONENT VIDEO
2 3
Y PB PR
AC IN
R -AUDIO -L AUDIO OUTPUT
• Connect the 75-ohm coaxial cable (commercially available) to the
ANT (antenna input) terminal.
If your outdoor antenna uses a 75-ohm coaxial cable with a standard DIN45325 plug
(IEC169-2), plug it into the antenna terminal at the rear of the Media Receiver.
SYSTEM CABLE WHITE BLACK
SYSTEM CABLE
WHITE
BLACK
ANT
INPUT 2
INPUT 1
SERVICE ONLY
INPUT
I /o link.A SELECT
INPUT 2
INPUT 3 HDMI SYSTEM CABLE BLACK WHITE
COMPONENT VIDEO
2 3
Y PB PR
AC IN
R -AUDIO -L AUDIO OUTPUT
Europe, except UK
and Eire
UK and Eire
Media Receiver (rear view)
Europe, except UK
and Eire
UK and Eire
To AC IN
Cable tie
Ferrite core
Attaching the ferrite core
To help prevent noise, attach the supplied ferrite core
to the connector end of the power cord as shown. Use
the supplied cable tie to prevent the ferrite core from
slipping on the cable.
As close as possible AC power cord
To power
outlet