Pioneer PDK-TS24 - Manual (Page 6)

6
En
11 (13/32)
Side View
12 mm to 15 mm
(1/2 to 5/8 inch)
Using a wall for stabilization
1
Attaching falling prevention bolts to the
Plasma Display.
2
Using strong cords to firmly stabilize it
appropriately and firmly to a wall, pillar, or
other sturdy element.
Perform this work in the same way on the left and right
sides.
Note
Use hooks, ropes, and fittings
that are available on the market.
Recommended hook:
Nominal diameter M8
Length 12 mm to 15 mm (1/2 to 5/8 inch)
1
Hook
2
Cords
Fittings
Stabilizing on TV table or other location
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
To stabilize the Plasma Display on a TV table, use screws that
have a nominal diameter of 6 mm (1/4 inch).
Select the appropriate screws after consulting a professional
installer if necessary.
After installing the stand, be sure to take special care to ensure that the equipment will not fall over.
Because of the plasma display’s weight, if it could fall down, this can result in injury.
For safety, be sure to take special care to ensure that the Plasma Display will not fall over.
Position of table screws
To stabilize the Plasma Display on a TV table, use screws
that have a nominal diameter of 6 mm (1/4 inch).
Unit: mm (inch)
*: 50 inch display model
**:42 inch display model
301 (11-27/32)
24 (15/16)
120
(4-23/32)
460(18-1/8 )**
552(21-23/32 ) *
Preventing Equipment from Falling Over
Dimension without speakers
Caution
• A TV table with adequate strength should always be
used to support the Plasma Display.
Failure to do so could result in personal injury and
physical damage.
• If you do not take these precautions, the Plasma
Display could fall down and cause injury.
• The screws, hooks and other fittings that you use to
secure the Plasma Display to prevent it from
overturning will vary according to the composition and
thickness of the surface to which it will be attached.
• Select the appropriate screws, hooks and other fittings
after first inspecting the surface carefully to determine
its thickness and composition and after consulting a
professional installer if necessary.
Min. 20 mm
(13/16 inch)
9 mm to 15 mm (3/8 to 5/8 inch)
6 mm (1/4 inch)