Pioneer AVH-5400DVD - Manual (Page 36)

System settings
Switching the auxiliary setting
Activate this setting when using an auxiliary
device connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 28.
2 Touch AUX Input on the system menu
to turn AUX Input on or off.
Setting AV input
Activate this setting when using an external
video component connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 28.
2 Touch AV Input on the system menu to
turn AV Input on or off.
Setting the rear output and
subwoofer controller
This unit's rear speaker leads can be con-
nected with full-range speaker (
Full) or sub-
woofer ( Subwoofer). If you switch the rear
speaker setting to Subwoofer, you can con-
nect the lead directly to a subwoofer without
using an auxiliary amp.
! When no subwoofer is connected to the
rear output, select Full (full-range speaker).
! If the rear speaker leads are connected
with a subwoofer, select Subwoofer (sub-
woofer).
This unit's rear output (RCA rear output) can
be used for subwoofer (
Subwoofer) or rear
( Rear Speaker) connection.
! When no subwoofer is connected to the
rear output, select Rear Speaker (Rear).
! When a subwoofer is connected to the rear
output, select Subwoofer (subwoofer).
1 Turn the unit off.
Refer to Basic operations of this unit on page
10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 28.
3 Touch Rear Speaker on the system
menu.
Rear Speaker items are displayed.
# Rear Speaker – Adjust the rear speaker con-
nection.
# Preout – Adjust the preout connection.
4 Touch Rear Speaker item to select the
desired rear speaker setting appears.
# Rear Speaker can be set Full or Subwoofer.
# Preout can be set Subwoofer or Rear.
Notes
! Even if you change this setting, there will be
no output unless you turn the subwoofer out-
put on (refer to Using subwoofer output on
page 30).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
Setting the FM tuning step
Normally, the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to
100 kHz. It may be preferable to set the tuning
step to 50 kHz when AF is on.
! The tuning step remains at 50 kHz during
manual tuning.
1 Turn the unit off.
Refer to Basic operations of this unit on page
10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 28.
En
36
Section
10 Menu operations