Billion Electric Company BIPAC 7402NX - Manual (Page 31)

Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router
Chapter 4: Configuration
30
You can setup member ports for each VLAN group under Bridge Interface section. From the example, two
VLAN groups need to be created.
Ethernet: P1 and P2 (Port 1, 2).
Ethernet1: P3, P4 and Wireless (Port 3, 4, Wireless). Uncheck P3, P4 and Wireless from Ethernet VLAN
port first.
Note: You should setup each VLAN group with caution. Each Bridge Interface is arranged in this order.
Bridge Interface VLAN Port (Always starts with)
ethernet P1 / P2 / P3 / P4 / Wireless
ethernet1 P2 / P3 / P4 / Wireless
ethernet2 P3 / P4 / Wireless
ethernet3 P4 / Wireless
ethernet4 Wireless
Management Interface: To specify which VLAN group has possibility to do device management, like
doing web management.
Note: NAT/NAPT can be applied to management interface only
Ethernet
Primary IP Address
IP Address: The default IP on this router.
Subnet Mask: The default subnet mask on this router.
RIP: RIP v1, RIP v2, and RIP v2 Multicast. Check to enable RIP function.