Pioneer X-SMC55DAB-S - Manual (Page 26)

Connect to network 08
26
En
6 If using a wireless LAN connection, input the
router’s SSID, then select the “Security” item set
on the router.
Also, if input of a fixed IP is required, set DHCP to OFF here
and make the setting.
7 If a password is requested, input it here.
8 When settings are completed, click on
“Apply”.
The unit will automatically power down.
9 Disconnect the LAN cable from the unit and
confirm that the router’s power is ON.
If you intend to use the unit in a wired configuration, use a
LAN cable to connect the unit to the router.
10 Press  STANDBY/ON.
When the power is completely on, the NETWORK indicator
will light white, indicating that settings are completed.
IP Address
The IP address to be entered must be defined within the
following ranges. If the IP address defined is beyond the
following ranges, you cannot play back audio files stored
on components on the network or listen to Internet
Radio stations.
Class A: 10.0.0.1 to 10.255.255.254 / Class B: 172.16.0.1
to 172.31.255.254 / Class C: 192.168.0.1 to
192.168.255.254
Subnet Mask
If an xDSL modem or a terminal adapter is directly
connected to this unit, enter the subnet mask listed in
your ISP documentation. In most of the cases, enter
255.255.255.0.
Default Gateway
If a gateway (router) is connected to this unit, enter the
corresponding IP address.
Primary DNS Server/Secondary DNS Server
If there is only one DNS server address listed in your ISP
documentation, enter Primary DNS Server. In case
there are more than two DNS server addresses, enter
Alternate DNS
in the other DNS server address field.
Proxy Setup
Select Use Proxy Server when you connect this unit to
the Internet via a proxy server. Enter the Proxy Host
Name
and the port number of your proxy server in the
Proxy Port field.
B: Wired connection to a router
with DHCP server
1 Disconnect the power cord from AC power
before performing the connection between
router and this unit.
Use a LAN cable to connect this unit and your router.
2 Connect the AC adapter, and press
 STANDBY/ON.
Wait for about 30 to 40 seconds.
3 when the power is fully turned on, the
NETWORK indicator will light white.
X-SMC55DAB-S_VXE8_En.book 26 ページ ２０１３年７月３０日 火曜日 午前９時４分