Pioneer PDP-435FDE - Manual (Page 34)

09 Basic Adjustment Settings
34
En
Power Control
Power Control provides convenient functions for power
saving.
Energy Save
Power consumption is saved by decreasing picture bright-
ness.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER).
3 Select “Energy Save” ( / then ENTER).
4 Select “Save” or “Picture Off” ( / then ENTER).
Item Description
Standard Does not decrease picture brightness.
(factory default)
Save Decreases picture brightness to save
power.
Picture Off Deactivates the screen to save power. To
restore the screen display, press any
button other than i +/i – and
e.
This setting is not memorised by the
system.
5 Press HOME MENU to exit the menu.
No Signal off
The system will be automatically placed into the standby
mode if no signal is received for 15 minutes.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER).
3 Select “No Signal off” ( / then ENTER).
4 Select “Enable” ( / then ENTER).
Item Description
Disable Does not place the system into the
(factory default) standby mode.
Enable Places the system into the standby mode if
no signal is received for 15 minutes.
5 Press HOME MENU to exit the menu.
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Media Receiver after a TV
programme finishes.
No Operation off
The system will be automatically placed into the standby
mode when no operation is performed for three hours.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER).
3 Select “No Operation off” ( / then ENTER).
4 Select “Enable” ( / then ENTER).
Item Description
Disable Does not place the system into the
(factory default) standby mode.
Enable Places the system into the standby mode if
no operation is performed for three hours.
5 Press HOME MENU to exit the menu.
• Five minutes before the system is placed into the standby
mode, a message appears every minute.