Pioneer SC-LX78-K - Manual (Page 86)

86
Using other functions
09
Using the sleep timer
The sleep timer switches the receiver into standby after a specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use the remote control to set the sleep timer.
% Press SLEEP repeatedly to set the sleep time.
30 min 60 min
Off 90 min
! You can check the remaining sleep time at any time by pressing SLEEP once. Pressing repeatedly will cycle
through the sleep options again.
! The sleep timer is valid for all zones. If any zone is on, the sleep timer continues functioning.
Dimming the display
You can choose between four brightness levels for the front panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
Turning off the display is effective for suppressing noise from the display that affects sound quality.
% Press DIMMER repeatedly to change the brightness of the front panel display.
! You can also choose to turn the display off. In this case, the FL OFF indicator lights.
Checking your system settings
Use the status display screen to check your current settings for features such as surround back channel process-
ing and your current MCACC preset.
1 Press STATUS.
2 Use
i/j to check the system setting.
The information on the main unit display switches as shown below each time one of the buttons is pressed.
IP address
f Audio format f Sampling frequency f MCACC memory f Auto phase control plus correc-
tion value f Input source to be played in ZONE 2 f Input source to be played in ZONE 3 f Input source to
be played in HDZONE f HDMI output setting f Subzone to which HDZONE is output
! For some settings, some items are not displayed.
3 When you’re finished, press STATUS again to switch off the display.