Pioneer DEH-P6400R - Manual (Page 38)

Initial Settings
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car’s headlights are turned on. You
can switch dimmer on or off.
1 Press FUNCTION to select DIM .
Press FUNCTION repeatedly until Dimmer
appears in the display.
2 Select DIM on or off with
5/∞.
Pressing
5/∞ will switch
Dimmer between on
and off and that status will be displayed (e.g.,
Dimmer :ON ).
Selecting the brightness
You can select the display brightness. Initially
this mode is set to 12.
1 Press FUNCTION to select BRIGHT .
Press FUNCTION repeatedly until Brightness
appears in the display.
2 Select the desired brightness with
2/3.
• The display shows 0 – 15 .
Switching the rear output setting
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer out-
put on (refer to Using subwoofer output on
page 34).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
1 Press FUNCTION to select SW .
Press FUNCTION repeatedly until FRT+REAR
appears in the display.
2 Select full-range speaker or subwoofer
with
2/3.
Pressing
2/3 will switch between
FRT+REAR
(full-range speaker) and FRT+SW (subwoofer)
and that status will be displayed.
En 38
08
Section