Pioneer DEH-P6400R - Manual (Page 11)

Tuner
En 11
Listening to the radio
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on page 12.
This unit’s AF (alternative frequencies search)
function can be switched on and off. AF should
be off for normal tuning operation (refer to page
15).
1
STEREO ( ST ) indicator
Shows that the frequency selected is being
broadcast in stereo.
2
BAND indicator
Shows which band the radio is tuned to, MW,
LW or FM.
3 PRESET NUMBER indicator
Shows what preset has been selected.
4
FREQUENCY indicator
Shows to which frequency the tuner is
tuned.
1 Press SOURCE to select the tuner .
Press SOURCE until you see Tuner displayed.
2 Use VOLUME to adjust the sound level.
Rotate to increase or decrease the volume.
3 Press BAND/ESC to select a band .
Press BAND/ESC until the desired band is dis-
played, FM1 , FM2 , FM3 for FM or MW/LW .
4 To perform manual tuning, press
2 or 3
with quick presses.
The frequencies move up or down step by step.
5 To perform seek tuning, press and hold
2
or
3 for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
• You can cancel seek tuning by pressing either
2 or 3 with a quick press.
• If you press and hold
2 or 3 you can skip
broadcasting stations. Seek tuning starts as
soon as you release the buttons.
Note
• When the frequency selected is being broad-
cast in stereo the STEREO (ST) indicator will
light.
1 2 3
4
English
Español
Deutsch
F
rançais
Italiano
Nederlands
03
Section